Prof. Manzar Abbas

Manzar Abbas, physicist

Prof. Manzar Abbas is a physicist and advisor at the Department of Physics, COMSATS University Islamabad, where he has contributed since 2002. His research career spans over four decades, with contributions to thin film technology, solar cell fabrication, electron beam evaporation and semiconductor device physics.

His work has taken him from Pakistan to Europe, collaborating with researchers at EPFL in Switzerland, the University of Turin in Italy and the University of Newcastle in Australia. With 41 publications, 97 citations and over 2,300 reads, his research continues to be referenced in vacuum deposition, thin film characterization and photovoltaic technology.

From early work on low-cost metallization for solar cells to pioneering studies on quantum dot sensitized solar cells and carbon nanotube infrared sensors, Prof. Abbas has consistently pushed the boundaries of materials science and semiconductor physics.

Education

M.Phil, Physics

1980

Quaid-e-Azam University, Islamabad, Pakistan

Career

  1. 1977–1982

    Lecturer, Physics

    Government College, Rawalpindi, Pakistan

    Teaching physics to undergraduate students

  2. 1982–2002

    Senior Research Officer

    Pakistan Council of Renewable Energy Technologies (PCRET), Islamabad

    Research and development in solar cell fabrication and thin film technology

  3. 2002–2011

    Assistant Professor, Physics

    COMSATS Institute of Information Technology, Islamabad

    University-level teaching and semiconductor research supervision

  4. 2011–2018

    Advisor, Physics

    COMSATS University Islamabad

    Advisory role in Department of Physics research programs

  5. 2018–Present

    Visiting Professor, Physics

    Quaid-e-Azam University, Islamabad

    Continuing academic contribution at Pakistan’s premier research university

Training around the world

Six trainings in five countries, over four decades.

Germany

1984

Leybold Heraeus, Hanau

Installation and operation of high vacuum coating systems (heat resistive and electron beam type)

Italy

1989–1990

ICTP Italian Laboratories, Turin (1 full year)

R&D on amorphous silicon films and ITO thin film growth under International Centre for Theoretical Physics program

China

2000

Tianjin Institute of Power Sources (TIPS)

Training in silicon solar cell photovoltaics (2 weeks)

Kazakhstan

2000

Kazakhstan State National University, Almaty

Training in GaAs/Ga(Al)As photovoltaics (10 days)

USA

2006 and 2008–2009

University of Delaware, Newark (9 months total)

Research and training on organic/inorganic and quantum dot solar cells at the Department of Materials Science and Engineering

USA

2007

Material Development Corporation (MDC), California

Training on CV systems for resistivity and carrier concentration measurements in semiconductors

In the laboratory

Equipment and characterization techniques used across forty years of research.

Fabrication

  • Silicon Single Crystal Growth System
  • Diffusion Furnace
  • LPCVD System
  • Magnetron Sputtering System
  • High Vacuum Thin Film Coating Systems
  • Laser Ablation System
  • Screen Printers (Solar Cell Metallization)
  • Spin Coaters and Spray Pyrolysis System
  • Glove Boxes (Organic Device Fabrication)
  • Sun Simulators (Solar Cell I-V Characterization)
  • Laminators (Solar Module Fabrication)

Characterization

  • UV-VIS-NIR Spectroscopy (Transmittance / Reflectance / Band Gap)
  • Hall Effect (Resistivity, Mobility, Carrier Concentration)
  • CV/IV Semiconductor Measurement System
  • XRD (Structural Properties and Element Identification)
  • SEM/EDX (Surface Morphology and Elemental Analysis)
  • Ellipsometer / Telestep (Thin Film Thickness and Refractive Index)
  • Four Point Probe / Van der Pauw (Resistivity)
  • Fourier Transform Spectroscopy (IR Bands)

Expertise

  • Thin Films Fabrication by Electron Beam Evaporation
  • Solar Cells
  • PECVD
  • Semiconductor Devices
  • Chemical Vapor Deposition
  • Quantum Dots
  • Ferromagnetism